doctor-hill.com
Carl Zeiss Meditec IOL Master
Cataract Surgery Arizona

IOLMaster — Exit Program.

IOLMaster E KEY

Switch Off — Shut Down — Exit Program

  1. When all measurements have been completed, exit the program by pressing the EXIT icon (as shown above) or <E> key.
  2. Then press OK or <ENTER>. The data of the current (last) patient will be saved automatically.
  3. When the "It's now safe to turn off" message appears, turn the IOLMaster off by the main switch.
  4. Wait until the screen goes off before pulling the main plug or switching off at the main.
caution

IMPORTANT: When the power switch is turned off while the IOLMaster is in operation, the software automatically quits. Be sure to wait until the screen is BLANK before unplugging the IOLMaster or switching off the electric source.

Disconnecting the IOLMaster whilst the IOLMaster is running, will interfere with the software shutting down properly. This may lead to loss of data or major errors in the IOLMaster's software.


Optical Coherence Biometry Note
The procedure described above does not apply in the case of breakdowns or if the IOLMaster does not respond to your input. If this occurs, switch off the IOLMaster immediately and disconnect the power cable. Label the IOLMaster as being defective and call Carl Zeiss Service.


Restart the IOL Master, by observing the instructions in: Troubleshooting.